1. Wall bracket suitable used for blind and shade operation system. 2. Wall bracket have to operate with bracket pin stud, motor pin stud at the head side of tubular motor and end cap, bearing at the end side of motor. 3. All of the ...
1. Plastice bearing was applied for end of tubular motor and it was usually screwed on the wall bracket. 2. Plastic have to operate with end cap and they are usually applied on shutter operator system. 3. Light shutter was suitable for ...
1. Ø45 motor pin stud was designed screwed on the head of 45mm tubular motor. 2. It was suitable for shutter operation system. 3. It was usually applied for heavy shutter system and it can make power of motor performance smoothly.
1. Ø28 bearing bracket was designed for tubular motor installed at the end of tube. 2. It was suitable for shutter and heavy operation system. 3. It have to opoerate with Ø12 bearing and it can offer good holding performance for operating.
1. Ø35/Ø45 motor pin stud was designed screwed on the head of 35mm and 45mm tubular motor. 2. It was suitable for blind or projection screen operation system. 3. It can be screwed on wall bracket or fixed on the wall directly.
1. Ø44 octagonal aluminum tube was designed for TESC 35mm tubular motor. 2. It was operate with octagonal drive adapter. 3. Tubular motor have to insert into aluminum tube, then it work. 4. Length of tube will depends on width of your ...
1. Ø35 motor pin stud was specialized for 35mm tubular motor use only. 2. It was usually operate with bracket pin stud and used for light shutter operation system. 3. Good motor pin system can make stable operation performance.
1. Mounting stud was designed for tubular motor at the head of tube. 2. It was suitable for shutters and heavy operation system and it have to opoerate with motor square bolt pin stud. 3. It can offer good and stable holding performance for ...
1. Ø12mm shaft stud was designed for install at the end of tube. 2. It was suitable for blind or projection screen operation system for reduce gap between the wall. 3. It can be screwed on wall bracket or fixed on the wall directly.
1. Ø12 bearing was designed for tubular motor installed at the end of tube. 2. It was suitable for shutter and heavy operation system. 3. It have to opoerate with Ø28 bearing bracket and it can offer good lubricity performance for operating.
| Company Name : | Tong Eann Shutters Co., Ltd. |
|---|---|
| Contact Person : | Ms. Jessie Chen  |
| Address : | No. 22, Lane 130, Huh Ann Rd., Ching Sho |
| Country : |  Taiwan |
| Telephone : | 886-4-26112999 |
| Fax : | 886-4-26112826 |
