1.Fully automatic from PCB Feeding→Pin Clipping→Pin inserting→Pin Cutting→Pin
and PCB Riveting→PCB withdraw. It doesn't need the specialized technical
personnel, and a person to be possible operand
2.Firmly Riveted, remain coating perfectly and there will be loosen,
and lack of pull and push force.
3.The length of inserted terminal could be adjusted.
There are no over stocks problems.
4.Terminals will not be touched by human hand and without vibration Therefore,
terminals will not be oxidized an darken.
5.There is no need to soldering tin and no need to clean the tin dregs.
6.Round & flat pin altogether uses,may propose the high production energy,
and can reduce the cost and not be good rate
Taiwan
