1. Amp-10 is built for the purpose to transmit the GPS satellite signal from outdoor to indoor, and re-radiating the receptions for multi-users to operate GPS Receivers inside buildings or vehicles.
2. For L1 band GPS signal, meets most of the GPS Receivers on the market.
3. Amp-10 is a re-radiating equipment. It can receive the outdoor GPS satellite signal and conduct to indoor place for radiating again. When a GPS Satellite is revolving around the earth it will transmit continuously satellite signal to the earth, but the strength of satellite signal will weaken to only around -125dBm when it arrived to the earth ground. Such weak signal can't penetrate into buildings or vehicles; besides, its reflection or scattering signal can be detected only in around windows area.
4. Amp-10 is built for the purpose to transmit the GPS satellite signal from outdoor to indoor, and re-radiating the receptions for multi-users to operate GPS Receivers inside buildings or vehicles. Therefore, users can work the GPSequipments indoor same as using it outdoor.
1. Power required: 10~26VDC, less than 25mA, @12VDC input (active antenna not included).
2. Gain: ~24dB.
3. Frequency: L1 band, 1575.42 +/- 10MHz.
4. LED indication: red (for power input).
5. Operation temperature: -40 ? ~ +80 ?.
6. Operation humidity: 5% ~ 95%.
7. Dimension: 107 x 67 x 20 mm (main body).
8. Weight: 110 g.
9. Radiation antenna: the length of dipole are 6 cm the length of RG-174U cable are 200 cm.
10. Radiation antenna range: one meter around.
11. MCX connector: providing 5V, 25mA power for the external active antenna.
12. External active antenna impedance: 50 ohm.
13. External antenna gain: average 26dB need, for 2-5 meter cable, but it may depends on the length of cable.
Taiwan
